November 2015Oktober 2015Technical, Mechanical & EngineeringYogyakarta

Alignment Pump and Motor

Jadwal Training Alignment Pump and Motor:

    Instructor by : Gregorius Harjanto 



    Motor-Pump alignment is the process of aligning shaft centerlines between a motor and a pump. The motor is the prime mover, transferring power to the pump by the use of a coupling. This is probably the most common configuration of coupled machines in industry.

    In this type of alignment, the motor is almost always the moveable machine, and the pump is the stationary machine. In almost all cases, the pump is already piped up with suction and discharge flanges, which means it can move only slightly, if at all.

    motor-pump-alignmentProper shaft alignment is achieved by moving the motor. The motor is shimmed vertically to achieve the proper elevation to align it to the pump, both parallel (offset) and angular. The motor is them moved horizontally to achieve proper horizontal placement for aligning the shaft centerlines, both parallel and angular. The motor is moved horizontally by the use of jacking bolts, or by the use of pry bars, hammers, or other tools.

    Motors are normally easier to move, since the motor is not piped into a process system. A short run of flexible conduit is most often used to run the electrical wiring from a local disconnect, or a rigid conduit, to the motor termination box. This allows for ease of movement of the motor.


    MATERI Training Alignment Pump and Motor 

    1. Fundamental Alignment

    2. Diagnosing Misalignment

    3. Measuring Misalignment

    4. Preparing Task Alignment

    5. Alignment Methods (praktis)

    • Rough Methods
    • Face and Rim

    6. Alignment Tolerances

    7. Complicating Factor Alignment.

    8. Introduction to Laser Alignment

    9. Minimizes the forces of misalignment acting upon the bearings and seals of both components.

    10. Minimizes Wear of The Coupling.

    11. Reduce Energy Costs.

    12. Maximizes the life of the Machine Components by Minimizing Wear, ncreasing time between failures, and reducing vibration.





    Case Study




    Training Kit

    Flash disc



    Lunch + 2 X Coffee Break


    Pick Up Participant


    TRAINING FEE for Alignment Pump and Motor

    Rp. 8.000.000,- / participant / Non residential

    Quota minimal 3 orang peserta

    Form Pre-Registrasi

    Data Materi Training

    Topik Training : Alignment Pump and Motor
    *Jumlah Peserta Estimasi Jumlah Peserta yang di ajukan
    *Nama Peserta Yang Didaftarkan

    Personal Data

    *Jabatan Jabatan/Divisi/Departement
    *Nama Perusahaan
    *Alamat Perusahaan
    *Email Perusahaan
    *Email Alternatif eg: gmail, yahoo, hotmail
    *Telepon Kantor
    * Harus di isi
    , , , , , , , , , , ,

    Related Articles

    Check Also

    *Semua Silabus dan jadwal training yang ada di Training SDM adalah milik dari masing-masing vendor penyelenggara training.